Newland FM208 Betriebsanweisung PDF herunterladen (Seite 106)

nlscan.com

Page 101

Message Intersect & Pack

1D, Program Intersect Option

A command input consists of 3 decimals. The first input is for barcode format; Refer to “Symbologies ID

Number”. The second input is for intersecting direction; “000” denotes ascending (left to right) and “001”

denotes descending. The following 2 inputs are for start digital and end digital.

For example, intersect EAN-13 from 1st digit to 3rd ascending and from reciprocal 4th to reciprocal 1st.

1. Read “Code Programming ON”

2. Read “Allow Intersection”

3. Read “Add Intersect Option”

4. Check Symbologies ID Number table for EAN-13

5. Read digit barcodes in the bellow

0 0 5 0 0 0 0 0 1 0 0 3 0 0 1 0 0 4 0 0 1

symbology ID ascending the 1st digit the 3rd digit descending the 4th digit the 1st digit

How to clear a certain 1D barcode Intersection Setting?

E.g: If you want to cancel the EAN-13 Intersection Settings, take the processing as below;

Read “Enable Code Programming” bar code first1.

Read “Clear a barcode Intersection setting”2.

Check Symbologies ID Number table for EAN-1

3Code as “005”3.

Read corresponding number barcode below4.

Read “save” and “Disable Code Programming” codes5.

Rules:

1. Maximum intersect 5 barcode message sections

2. Maximum value is 127 for start digital and end digital

3. Overlaps of barcode message sections are allowed and work independently.

4. Start digital and end digital determine its message section sequence. In the above example, desce

nding

“004” and “001” determine the section sequence to be “reciprocal 4th”, “reciprocal 3rd”, “reciprocal

2nd”, “reciprocal 1st”

5. to intersect only one digit, program start digital and end digital to be the same value

Message Intersect

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 112 113 114

Keine Kommentare

Newland FM208 Betriebsanweisung Seite 106